A Step-by-Step Guide in DIY Installation of Artificial Lawn

A lush and green lawn is every homeowner’s dream. Whether you have a small or spacious front yard, it definitely makes your home extra beautiful when you turn it into a green lawn. However, maintaining a healthy-looking lawn takes a lot of effort and time.

If you’re a busy type of person, you might find it really demanding to maintain a lovely lawn. One of the best solutions for this is using fake grass in your lawn. Aside from having little to zero maintenance, it also stays green all throughout the year no matter what the season is. If it sounds like a perfect solution to what you need, then here’s a step-by-step guide on how to install artificial lawn in your home. 

Prepare the Tools Needed

First, you should have all the necessary tools to make installation easy and convenient. You should have a hammer, flathead nails, measuring tape, shovel, rake, knife, compactor, blower, crushed rock, whitewash sand, water, and synthetic grass.

Remove the Current Turf

Preparing the space is essential to be sure that your artificial turf holds well and stays long. Clean up the area first by removing the current turf, debris, rocks, or anything that would interfere during the installation. Excavate about 80mm of the area to have a bed for your turf. After excavating, remove the debris and level the ground.

Compacting the Base

Spread the finely crushed rock on the bed evenly to serve as a sub-base. Spray it all over with water and use a compactor to compact the crushed rock base until it becomes sturdy. When the area feels steady, you can now proceed to the next step.

Put in the Artificial Turf

When the base is compact, it’s time to lay out the artificial turf. Be sure to buy quality artificial lawn for sale from trusted suppliers. Unroll the turf for a few hours to even out all the folds and creases before using it. Measure how much artificial turf you need and cut it using a utility knife. Lay the turf down on the base making sure that each piece is going to the same direction for a seamless look. Also, see to it that each piece overlaps each other so you could easily join them together with an adhesive.

Trim and Adjust the Turf

Move around the artificial lawn and trim protruding edges for a seamless look. After trimming, be sure that your lawn won’t move around by nailing it to the bed. Use a thin nail and nail it along the edges to secure the turf in place. It is best to put a nail for every 30cm.


To make your turf look more natural, it is important that you sand it after installation. Gently spread whitewash sand all over the lawn and spread it more evenly using a rake.

Installing artificial turf is not that hard at all if you know the basic steps needed to do it properly.

Comments are closed.